On Orders Of $200
The TTI Ultimate Benelli Power Pak Spring Set comes with the:
Ultimate Reduced-Power Buffer Spring.
Ultimate Reduced-Power Hammer Spring.
Ultimate Reduced Power Trigger Spring and additional C-Clips.
Posted by Jon Stichler on Mar 11th 2018
I was really impressed with the difference it made with my M2. I use mine for sporting clays and it is by far one of the best upgrades I have put on it.
40$ well spent!!
Posted by Taylor on Jan 31st 2018
Installed power pak on my Benelli Montefeltro, tested it this hunting season, operated flawlessly!
TTI Simple the BEST
Posted by Gloryboy3/75 on Jan 3rd 2018
Product quality is what you would expect from TTI. I Love the fact you get a few extra retaining clips in the package
Must have for everyone!
Posted by James Farrier on Oct 24th 2017
It's like putting a cheat code in. Such an inexpensive upgrade for such a big enhancement. Easy to install, but if you need help BullittMcQueen on youtube does a good walk through.
Should have done this sooner
Posted by Unknown on Jul 6th 2017
My 3gun M2 would occasionally have a failure to fully eject a shell from the mag tube onto the lifter. After this affordable and simple install had zero malfunctions in following matches . If your having issues cycling low recoil shells get this kit and run quality ammo I run Fiochi 1oz 1175fps
Posted by Bryant A Larimore on Mar 14th 2017
This was a perfect upgrade from the stock springs. Trigger pull is crisp and light. Target loads under 1200 FPS cycle perfectly now. Definitely worth the price!
Just what I needed!
Posted by Unknown on Mar 11th 2017
Installed the spring kit and the trigger now is nice and light. Before it was hard and stiff around 10lbs now its 3.5lbs.
Changed my Benelli for the good. Awesome Product!!
Posted by William Rownd on Aug 10th 2016
Heard a lot about this spring kit. I can tell you that my gun cycles 1145FPS shells without a problem now. 1&1/8 and 1 Ounce shot cycle perfectly. Thanks
TTI Ultimate Benelli Power Pak Spring Set
Posted by Unknown on Jul 28th 2016
Installed the trigger and hammer spring first, noticed a nice difference in the improved trigger pull and reset.
My M2 was having problems cycling lower recoil loads..... after installing the new buffer spring, my M2 had no problems eating the first 100 Winchester 1145 velocity Light Target Loads.
Just make sure you watch a youtube video for ease of installation.
Posted by Mark on May 31st 2016
I was rather impressed with the trigger pull, ease of installation, there are lots of good YouTube videos out there for the install of this! Anyone with a set or picks and moderate mechanical knowledge can do this! The only reason I gave it 4 of 5 stars is the magazine tube spring seems to be to small of a diameter and for the tube and seems harder to load shells than my factory spring especially on the 3rd of 3 loads! I just took a wire snips and cut about 3 rounds off the spring and it was great!