WOW it worked
M2 went from 5+ to 3 1/2 pounds with hammer spring and about 5 minutes of time
Designed to be used in conjunction with our Ultimate Reduced-Power Buffer/Hammer Spring, and Trigger Guard C-Clip.
Please check your local and state laws before purchasing. If your order needs to be refunded due to compliance issues, you will be subject to all applicable fees. Please see our Returns/Cancellations Terms for more information.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
M2 went from 5+ to 3 1/2 pounds with hammer spring and about 5 minutes of time
Installation was no issue and did it within 5 minutes of finally being able to sit down and accomplish the task. Installed put the gun back together to test fire the gun and make sure it worked properly in a dry fire. There was a noticeable reduction in trigger pull. I bought this in addition to the reduce hammer spring as I took my shotgun out for some trap shooting and noticed it struggled with the light loads. With the combination of the two, it seemed to dramatically reduce the action pull back as well. I go back out next week for some fun and will see how well everything holds up then.
Installation was super easy on Rem Versa Max Synthetic. Only installed the trigger reset spring, lessened the pull to 5.5 lbs from 8.25 lbs. This is a bird gun and occasional skeet gun, so it brought it to acceptable level. Worked fine with 1145 fps Federal and Winchester target loads, no issues with trigger reset on doubles. After early dove season I'll replace the hammer spring and see how much it lowers it from 5.5 lbs
