The TTI Ultimate Benelli Power Pak Spring Set comes with the following :
Ultimate Reduced-Power Buffer Spring.
Ultimate Reduced-Power Hammer Spring.
Ultimate Reduced Power Trigger Spring and additional C-Clips.
*Taran Tactical recommends that you go to a certified gunsmith or Glock armorer for installation*
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Installed the trigger and hammer spring first, noticed a nice difference in the improved trigger pull and reset. My M2 was having problems cycling lower recoil loads..... after installing the new buffer spring, my M2 had no problems eating the first 100 Winchester 1145 velocity Light Target Loads. Just make sure you watch a youtube video for ease of installation.
I was rather impressed with the trigger pull, ease of installation, there are lots of good YouTube videos out there for the install of this! Anyone with a set or picks and moderate mechanical knowledge can do this! The only reason I gave it 4 of 5 stars is the magazine tube spring seems to be to small of a diameter and for the tube and seems harder to load shells than my factory spring especially on the 3rd of 3 loads! I just took a wire snips and cut about 3 rounds off the spring and it was great!
