Material: SAE 1075 Spring Steel heat treated to 50 Rc, Electroless Nickel plate per MIL-C-26074E (military standard) and baked to remove embrittlement.
Connector will be compatible with Glock 43X, and Glock 48 firearms.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
DSCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols
I had installed a ghost edge connector in my glock 43 and was not happy with the feel. Too mushy, with no defined break. Installed the TTI connector and couldn't be happier. That, and a reduced power plunger spring put the pull just where it should be- crisp, yet an approximately 2 lb. reduction over stock. Highly recommend.
Easy to install and a great addition to the G43.
My G43 trigger was TERRIBLE. I have fired other G43's and for some reason my trigger was always much worse. Replaced stock connector with TTI's and now the gun is shootable. Took it from about a 10 pound pull to 5ish.
